This video shows you what to do if your HP printer does not pick up or feed paper from the input tray when you do have paper loaded and an "out of paper" message displays on the printer's control panel or on your computer. Sometimes the problem can be fixed just by doing a printer reset. First, make sure the printer is turned on. If it is off, press the power button. Next, turn to the back of the printer without turning the printer off and remove the power cord from the printer. Then, disconnect the other end of the power cord from its power source. Wait 15 seconds. It is important to wait the full 15 seconds for this type of reset. Reconnect the power cord to its power source, then reconnect the other end of the power cord into the printer. Return to the front of the printer. If the printer does not turn on automatically, press the power button to turn it on. Align a stack of paper by tapping it on a flat surface, then raise the output tray. Load paper into the input tray until it stops. Slide the paper width guide inward until it stops at the edge of the paper. Do not push the guide in so tightly that it starts to bend the paper. Lower the output tray. Try printing a page directly from the printer's control panel to see if the issue is resolved. On the printer's control panel, press the setup button, then touch "tools" and "printer status report". If the page prints successfully, the issue is resolved and you can resume printing as normal. If the page does not print, go on to the next step. Often, the condition of the paper you're using can cause paper not to...
Award-winning PDF software
Video instructions and help with filling out and completing Fill Form 3520 Wont
